THE BASE STRUCTURE DESIGN OF MOLDED POLYURETHANE RIGID FOAM
You are here: Home » News » THE BASE STRUCTURE DESIGN OF MOLDED POLYURETHANE RIGID FOAM

THE BASE STRUCTURE DESIGN OF MOLDED POLYURETHANE RIGID FOAM

Views:11     Author:Site Editor     Publish Time: 2020-11-23      Origin:Site

The base structure design of molded polyurethane rigid foam should be based on the actual engineering structure type, and put forward specific technical requirements, base treatment methods and quality control measures. The base layer of the molded polyurethane rigid foam is a load-bearing masonry wall. The strength grade of the block material should not be less than MU10; the strength grade of the block material filling the masonry wall should not be lower than MU5.0; The effective anchorage length should be greater than 25 mm. The masonry mortar of the masonry shall be full and shall meet the technical quality requirements of the dry wall. The joints between the filled masonry and concrete shear walls, beams and columns shall be laid with galvanized steel wire mesh and cement mortar shall be applied.


For more information on polyurethane, please continue to pay attention to the polyurethane manufacturer Hightop Machinery.

HOT NEWS

ABOUT US

Shandong Hightop Machinery Co.,LTD. (CNMC) is the leader in polyurethane technology, offers the best, most effective partner for high quality plural polyurethane and polyurea component systems.

CONTACT US

   hightoptools001
   sales@chnmach.com
    +86 5373151560
   +86 18653673192
Copyright © Shandong Hightop Machinery Co.,LTD. All rights reserved